Shengtian Industry range of cold- rolled, galvanised and hot -rolled sheet and plate which have been cut from coils. These sheets and plates can then be slit into multiple narrower widths used to fabricate flat bar, tubing and lip channel, or cut to custom lengths to suit fabricators’ and engineers’ specific requirements.
Our de-coiling and cut-to-length facilities produce thicknesses of 0,5-6,0 mm and widths of 925-1500 mm from hot-rolled, cold-rolled, and galvanised material. Guillotining facilities are available to manufacture 1,5-16,0 mm thicknesses with widths up to 3000 mm. Flame cutting facilities for up to 300 mm of flat sheet are also available. Our de-coiling and cut-to-length facilities can cut hot-rolled, cold-rolled and galvanised materials with thicknesses of 0,5-6,0 mm into 925-1500 mm wide sections.
What is the difference between steel sand, steel shot and steel wire cut shot?
How to buy good quality galvanized angle steel?
European standard channel steel product introduction
Quality standards for angle steel and matters needing attention when purchasing and accepting them
